Yes turn instructions use the name of the segment you are turning to (or inherited name from a future segment).
Between two segments you involved you have the Sin (this is the segment that you are leaving and I called outgoing segment) and the Sout (this is the segment that you are entering) Normally you are looking at the angle that the Destination segment makes to the first. This editor did not understand why you would go back to the TR from the first segment.
Yes most editors get it but since some don't I was asking if we should include it so that it is spelled out for all.
Between two segments you involved you have the Sin (this is the segment that you are leaving and I called outgoing segment) and the Sout (this is the segment that you are entering) Normally you are looking at the angle that the Destination segment makes to the first. This editor did not understand why you would go back to the TR from the first segment.
Yes most editors get it but since some don't I was asking if we should include it so that it is spelled out for all.
Re: [NEW] Guidance for turn instruction overrides