Done and done. Thanks.

Thanks. I'm still learning, and couldn't get it "connected" despite dragging the road across the other. Regarding the city, I see that you're right, it's not within Apex city limits, but mailing addresses surrounding that area are "Apex, NC". In the future, these should be left blank then?

Can you please abbreviate. Lane is Ln Court is Ct Drive is Dr

These do not need approval but Ten Ten road is locked at 3 so you were not able to connect your road there. I will lower that for you now so you can properly connect it.

Also you should consider joining us in slack. http://bit.ly/Waze_USA_SlackInvite

Please reply once you have finished these edits and I will look over them.


Sent from my iPhone using Tapatalk

The junction still was not connected at Woods Ct and Ten Ten. I went ahead and did that. Also made one other small change. Segments should not have a city name unless it is in the city limits. Based on all the surrounding roads it does not appear this is actually in Apex city limits. I see you joined Slack. Please feel free to ask any questions there or here.

If not in city check the none box beside the city name field. And yes sometimes it can be a little tricky when first starting to get roads to properly connect. Just takes some practice.