I thought I escaped the missing edits fine until just now, I found some roads I named just west of Toowoomba are back to red. Trying to use JNF to put terminations on the ends of these roads now results in the same error you are getting so theclem54 is most likley correct in that it is linked to the tile errors/missing edits.

ps_au, theclem, I have seen most of my edits returned to the editor, both that I had noticed missing and some I forgot doing. I even saw a few turn up in my area whilst I was using WME this afternoon including some missing user reports that I submitted weeks ago. Might be a good time to check your edits that had gone missing and retry failed ones like in the original post.

theclem54 wrote:There's a chance that the segment has already been fixed but the edit disappeared with the vanishing act of other edits from last weekend.

I've had about 20 of these since...
Patience patience....

Thanks clemmo... probably would have been better if I had bookmarked the ones that failed on me...

I believe this is a hangover of the bad tile update. I've seen similar errors elsewhere and have just put them aside pending a successful tile update (hopefully soon).

There's a chance that the segment has already been fixed but the edit disappeared with the vanishing act of other edits from last weekend.

I racked up over 400 edits of round-a-bouts and dead ends around Logan two nights ago, only to have the save fail and non of them went through. Luckily it was with the JNF plug-in and was only about 10 minutes lost, still enough that I closed it for the night and went to bed.

My editing has definitely slowed to a crawl pending a fix up (probably a good thing to have a bit of a break too).