Get a sneak peek at whats next for Permanent Hazards on our April 7th Office Hours!
The place to get information and ask questions about everything to do with properly and successfully editing the Waze Map.

Use this forum for all general editing questions, and the sub-forums for specific types of Waze Map Editor features.

Post Reply

Routing against prohibited turn, Logansport, IN

Post by Boiler_81
https://www.waze.com/editor/?zoom=5&lat ... s=16775976

This is a user reported error, the map has the proper turn restictions but the user was routed to turn at at prohibited turn
Boiler_81
Posts: 69
Has thanked: 7 times
Been thanked: 20 times

POSTER_ID:1716301

1

Send a message

Post by Boiler_81
Thank You for the direction. I did as you suggested and cleared the UR.

You are correct, George St is two way. I made that change as well.
Supernovareborn wrote:Since waze uses a penalty-based system for routing it is possible for routing against restricted turns. This becomes even more likely when there are so called "soft-restrictions" in place. I don't see anyone thing that sticks out (there's a bunch of little things, but you can say that about any area). Try clicking on the intersection node and using the Q key to set all restrictions to not permitted and then the W key to re-enable all. After this go back and set the appropriate turn restrictions. This will clear out any soft-turn restrictions.

-Supernovareborn

As a side note: is this street really one-way? https://www.waze.com/editor/?zoom=5&lat ... s=68969251 The aerial imagery appears to show a broken yellow line and cars driving against the set direction (outdated perhaps?)
Boiler_81
Posts: 69
Has thanked: 7 times
Been thanked: 20 times
Send a message

Post by supernovareborn
Since waze uses a penalty-based system for routing it is possible for routing against restricted turns. This becomes even more likely when there are so called "soft-restrictions" in place. I don't see anyone thing that sticks out (there's a bunch of little things, but you can say that about any area). Try clicking on the intersection node and using the Q key to set all restrictions to not permitted and then the W key to re-enable all. After this go back and set the appropriate turn restrictions. This will clear out any soft-turn restrictions.

-Supernovareborn

As a side note: is this street really one-way? https://www.waze.com/editor/?zoom=5&lat ... s=68969251 The aerial imagery appears to show a broken yellow line and cars driving against the set direction (outdated perhaps?)
supernovareborn
Posts: 90
Has thanked: 23 times
Send a message
Framingham, Natick, Sudbury and surrounding areas