Waze forum

Thank you for good job
I use this script for a long time
Version: WME Street to River PLUS 1.0 in your link does not work in Chrome

Please help

Thank you very much!
I tried to install it without Tampermonkey
All works perfectly

It doesn't work for me. I'm using it with Tampermonkey and Chrome.
Does it compatible wiht the latest WME?

aeytom wrote:I have uploaded a new version to userscripts.org. This new version integrates some changes from Timbones. Now you can create "railroad" landmarks with one click.

Thanks Tom!

Here's a summary of the changes:

• separate button to do 'Street to railway'
• default width of 8m (if not set in road name)
• creates landmark of type 'Other'
• will work on existing railroad segments

Have you switched on the Landmarks layer? (Shift+L) If you haven't, then it looks like the script hasn't worked.

ispyisail wrote:This gets me grumpy

[An error occurred while saving]

I draw a massive long river then I get this error and I have to start all over

Does any body else get this or is it just me?

I've seen this a lot, and I've tracked it down to corners where two points cross over each other. WME really doesn't like Landmarks that become twisted (kinda hard to describe).

Solution is to check the whole stretch of river, looking for pairs of geometry points that are very close together. Usually found near sharp corners of the river, and you might notice a missing point nearby. Delete one of the pair, and save. Repeat as necessary.

Do not try to create too long landmarks, it creates "general error". It is not a script error...