Today don`t work.

Best regards

OyyoDams wrote:

walbing wrote:Today don`t work.

Best regards

Have you updated loader ?

Thank you OyyoDams!!

Best regards

have trouble again, and I can not edit ..

Highlight segments with house numbers is not working for me with the Beta editor. (It works with the normal editor.)

OyyoDams wrote:

Watt25 wrote:Highlight segments with house numbers is not working for me with the Beta editor. (It works with the normal editor.)

Just fixed in 1.3.0.1

Thanks, but still have problem:
Normal editor works fine with all languages.
Beta editor works fine using English language. But house numbers still not highlighted in beta editor using anything else than English language.

May I report that WME Toolbox [loader] freezes my Firefox. The other scripts I have installed are WME Validator, WME JNF, WME Color Highlights and WME Aerial Shifter. They all work without problems on Google Chrome.

Edit: problem solved after uninstalling malfunctioning Flash

zannax wrote:

AlanOfTheBerg wrote:Would prefer u-turn highlight not be red. U-turn isn't a problem and a red highlight suggests something bad.

Are you sure that u-turns are not a problem?
In Italy we have wrong routing with enabled u-turns in segments without exit. Waze sometimes suggests to get in and out rather than go straight.

We have the same going on in the US. But right now that dead end node U-turn isn't highlighted at all, is it? A good option could be the dead end u-turn being red and u-turns at a normal intersection being a different color.

I installed it for the first time today, and it wouldn't load - same draggable error message.

Once you put in the debug steps, it started loading completely and was working nicely. Now you've done something else, and it runs to Step 1 - D, then doesn't complete.

Chrome version Version 27.0.1453.94 m on Vista

Thanks

OyyoDams wrote:Ok back. I've removed debug steps as I know where the bug happens from time to time. I can't reproduce it but I think it happens when the map loads slowly. I've added a timeout. Can you tell me if things are better ?

It's loading OK, but half the time, WMEOpenData stops loading now

I'll just have to keep restarting WME until it all works

Thanks

Strange problem arising yesterday and today with the Roundabout Repair tool.

It either works well

Or it seems to disconnect one of the segments and leave it adrift of the new roundabout, eg this one, if the editor hasn't fixed it yet.

Or, where there's a dual carriageway joining the roundabout, one or both carriageways get converted to two-way. That happened on this one, which I had to completely rebuild, and also this one immediately after, which I've also rebuilt.

I'm sorry that I didn't leave the two-way carriageways there, but I felt that was going to confuse everyone driving along there if I left it and an update was run, whereas the broken segment still looks connected, but won't route through there.

Hope that gives sufficient information for you to identify the cause.

Thanks for a great tool!