krzycholub wrote:Hi All,

Looks like JAI will not show u-turn prevention if the median segment has higher FC than other segments?
For example: median is mH and JAI will not display u-turn prevention

Hi,
Permalink Please??

Hi,

Look in the extensions if the old one is there. If so, delete it.

krzycholub wrote:

seb-d59 wrote:

krzycholub wrote:Hi All,

Looks like JAI will not show u-turn prevention if the median segment has higher FC than other segments?
For example: median is mH and JAI will not display u-turn prevention

Hi,
Permalink Please??

Tested on multiple intersections where median has higher FC with same results.

PL to one example

I noticed ...
It's been like this from the start, it's a part of the code that I never touched.

Hi,
I just push the update (v2.1.9) for the new zoom level.

MajkiiTelini wrote:...

More simple, just change line 2087 like this, no more : The problem is that now I18n contains only the active language of WME. Before there was also english by default.

I made this attached image to use with the Image Overlays script while creating or improving roundabouts, specifically to make it easy to ensure that roundabout attachments are within the correct parameters to produce "turn right", "turn left", "continue straight", etc.

Use Image Overlays to place and position this guide on top of where you will be placing your roundabout, and draw your roads so that when the RAB is added your attachment points will fit within the narrow forks relative to adjacent attached segments, and you're all set to generate clean roundabout turn instructions without any trial and error adjustments.

To allow plenty of margin for error, the angles on this guide are +/- 10 degrees instead of +/- 15, so you can actually fudge a little bit outside of the narrow forks and probably still be OK, just verify with JAI after you save your work.

Well, the really fun part is that I already use RA Util, but I had not used it in depth enough to realize that functionality was there, because I've been using it just to move and resize them, and was moving specific junctions manually.

Pretty humbling, lol. If it weren't for your very helpful reply benefiting from the context, I would have preferred to delete my previous post and gone to hide in the Humble Corner for a few days.

There is no angle info for roundabouts in new WME

If JAI is loaded with tampemonkey (chrome) there is no angle info in prod-WME. In beta-WME it is ok.
If JAI is loaded as a chrome extension, there is angle info in both prod & beta WME.

Still, there is no angle info for roundabouts.

There is no angle info for roundabouts in WME-prod. In WME-beta it is ok.