Get a sneak peek at whats next for Permanent Hazards on our April 7th Office Hours!

Post Reply

Split road segments

Post by houndtt
I note in some areas of the map a road is split in two or three segments. Is there a way to join discrete segments as a single road? I'm thinking that this may affect navigation calculations?
houndtt
Posts: 9
Has thanked: 1 time
Been thanked: 2 times

POSTER_ID:3589277

1

Send a message

Post by dknight212
You can delete the nodes between segments by clicking on them and click the rubbish bin icon. There is a small navigation penalty for each of these nodes.

David, using Tapatalk
dknight212
Posts: 4962
Has thanked: 367 times
Been thanked: 603 times
Send a message

Post by dknight212
Assuming you are using Papyrus (the new editor) it's top right just above the map display.

David, using Tapatalk
dknight212
Posts: 4962
Has thanked: 367 times
Been thanked: 603 times
Send a message

Post by dknight212
Have you found the rubbish bin?

David, using Tapatalk
dknight212
Posts: 4962
Has thanked: 367 times
Been thanked: 603 times
Send a message

Post by dknight212
Sorry misread your post. In the old editor click on remove junction then click on the junction to delete

David, using Tapatalk
dknight212
Posts: 4962
Has thanked: 367 times
Been thanked: 603 times
Send a message

Post by ivarturo
Where is that "the rubbish bin icon"??
ivarturo
Posts: 9
Send a message

Post by ivarturo
i'm using the old one cause i have problem with papyrus.
ivarturo
Posts: 9
Send a message

Post by ivarturo
okay. thanks.
ivarturo
Posts: 9
Send a message