1. Include the city and province in the "Subject:" line of your post.
2. Include a Permalink to the segment(s) you wish to unlock or have updated.
3. Provide a short explanation of why you need the unlock or update done.
4. Thank the user who solved the request and mark the thread Solved.


Please note that a higher level editor may choose to fix an unlock request themselves so higher value segments will remain protected at their level.

Post Reply
Forum rules
Instructions for posting (click here)

1. Include the city and province in the "Subject:" line of your post.
2. Include a Permalink to the segment(s) you wish to unlock or have updated.
3. Provide a short explanation of why you need the unlock or update done.
4. Thank the user who solved the request and mark the thread Solved.

Please note that a higher level editor may choose to fix an unlock request themselves so higher value segments will remain protected at their level.

Level4→L2 Unlock: Quebec - Longueuil (Saint-Hubert) (Boul Cousineau,Rue Bernard-Hubert)

Post by FrancoisSoucy
My Level: 2
Reason for request: need to connect new road and realign plr

Permalink
 
FrancoisSoucy
Posts: 92
Has thanked: 32 times
Been thanked: 1 time

Post by YogiJB
Hi François,

There are lowered to L2 now.
Note that the little Cousineau segments you added, should be coded as Parking Lot Roads too, without a name on it.

Furthermore, the entrances and exits are a bit long. As per this reference guide, the exit from Cousineau to the parking lot must only connect at the gore point (where the solid line starts and it's no longer allowed to switch lanes.) For the exit: connect it pretty much right away, so that instructions for the next intersection can be given as fast as possible.

Also, check your parking lot nodes. There are some reverse connections (with WME ToolBox, it should pop up the pink triangles.)

Please reply with the new permalink when done. :-)
 
YogiJB
Posts: 399
Has thanked: 19 times
Been thanked: 56 times

Post by FrancoisSoucy
Hi YogiJB, I hope I made it better this time !  Only thing...I don't have "reverse connections" options in my WME Toolbox...think because i'm L2 editor.  I have corrected 2 wrong connections I found in PLR.

Thanks again for your advice.

It's ready for relock

permalink
 
FrancoisSoucy
Posts: 92
Has thanked: 32 times
Been thanked: 1 time