I find the script very helpful, but ... I don't know if this bug is unique to me. See video. And that only happens when I activate your script.

https://watch.screencastify.com/v/2IokYd9uh4AFxNodrFxk
 

The intersection with the railroad segment is not pulled along properly.

So it would actually be correct:

https://watch.screencastify.com/v/W4ytUuBij0fWSGRsw5OH
 

TSWA wrote: ↑Sat Nov 20, 2021 7:58 pm Overwriting a problem with an announcement (TIO) does not solve the routing problem. So the problem persists and is not resolved.

There are also incorrect exits at roundabouts, which are generated by the WME (rarely), but cannot be seen with JAI alone.
Bad Jai fixes this problem as well.

 

 I was just about to say the same thing 
 
I am seeing quite a few RAs highlighted and have been wondering what the cause would be.

Horizon911 wrote: ↑Fri Jul 07, 2023 8:13 am 1. It should not highlight bad angles on roundabouts, e.g. here:
https://www.waze.com/en-US/editor?env=r ... t=20122919 

2. Should not highlight impossible turns, e.g. here:
https://www.waze.com/en-US/editor?env=r ... omLevel=21

 

Jump into the script settings

* There is an option to skip roundabouts.
* Turning on "Check for TIOs and Restrictions" seems to fix problem 2 as well.

Regards
ag

Hey,

after the last hotfix for productive WME Bad JAI shows yellow angle while there is/are TIO.

Hi @g1220k Gerhard, the error is back

G_W1Z wrote: ↑Fri Nov 19, 2021 12:19 am Is there a way the script can tell if a TIO was added to a bad angle to make it proper?


 

Hi, could you please send me an example PL of a "Bad Angle" which is made proper by TIO?
Thanks!
 

linguasaltitante wrote: ↑Sat Nov 20, 2021 10:22 am Thank you  ... I was looking for something like this for a while 
 
Is there a possibility to not show the error, if a TTS is forced on the node of the segments with the "45º"!? See this example. Because I'm overriding the instruction, there will no longer be a problem!

Also, a situation like this one shouldn't be marked with error, because there is no possibility to make a route between them (from one segment to the other and vice-versa).

Thank you once again for this script.
 
 
 

 

Thanks for the examples, I will try to take these situations into account.

Thank you for the numerous responses.
Since there have been various questions about the script and about bad and good angles in the last few days, I want to briefly explain my level of knowledge and the creation of the script.

I learned the following from my mentors:
A bad angle can cause the following problems:

• Unclear turning instructions
• Suboptimal routes

To solve this problem we change the angle by adding an additional node( or moving existing nodes).

In order to find the bad angles faster and easier, I developed the script "WME Bad Junction Angle Info".
Since we always fix bad angles by adjusting the angle, the script didn't have to take any TIOs or restrictions into account.

Now I have learned that work is done differently in other countries and that there are additional requirements for the script.
I'm already working on the new version, which will also check and take into account TIOs and restrictions.

The new version will be available in the next few days.