Check or Skip? 
As I understand should be "Skip"

What the above posters have said is correct. The only thing "bad" about junction angles near 45 degrees is that the automatic turn vs. exit/keep is unclear. If a voice prompt override ("TIO") is used, there is nothing "bad" about it.

linguasaltitante wrote: ↑Sat Nov 20, 2021 10:22 am 
Is there a possibility to not show the error, if a TTS is forced on the node of the segments with the "45º"!? See this example. Because I'm overriding the instruction, there will no longer be a problem! 


 

Overwriting a problem with an announcement (TIO) does not solve the routing problem. So the problem persists and is not resolved.

There are also incorrect exits at roundabouts, which are generated by the WME (rarely), but cannot be seen with JAI alone.
Bad Jai fixes this problem as well. 
 
 To correct this, I recommend using the ingenious WME RA (Roundabout) Util script:
https://greasyfork.org/de/scripts/23616-wme-ra-util
 
 
 

Just installed, very interesting script.

Here's an example where a TIO was setup to make up for the angle and it's still reported as "unsolved"  

I agree with Sketch, to the best of my knowledge there is no unresolved routing problem. The only issue is with the instruction and when the angle can't be increased or decreased (for whatever reason) then a TIO fixes that.

Also wondering about wether roundabouts should be marked or not however.

Would it be possible to add a setting to allow selection of the zoom level where the bubble appears?

Right now it is 15 but for example sometimes I'd prefer to have it set at 14 or 16 depending on the situation.

Makes sense, thanks for clarifying.

Thanks for the great script!
Can you change so that there will be no message when the junction with a roundabout?