skbun wrote:Something oddball in the way of a change has happened at least on the NA editor, and I can't put my finger on what it is.
Consider permalink https://www.waze.com/editor/?zoom=7&lat ... s=54685761
My attention was brought to this area because there's an automated report saying 'restricted turn might be allowed'. The thing is (as this is an express lane interchange) both ramps had direction 'Unknown' on them. However...if you look at streets in this area, you'll see that you're now only given three choices for directionals: One way A-B, One way B-A, and Two Way. Even the sister ramp attached to the one I saved as two way (I had no other choice!), shows the Xs I would associate with an 'Unknown direction' road, but I can't select it in the dropdowns.
Tried basic things to reset the segment like pulling its endnodes away from either side, saving, putting back...no go. I don't want to lose speed data for the segment, so I haven't done more than that and figured I'd put it out there to be investigated.
If I type 'R' to change the directions with the keyboard, 'Two Way' stays on screen for two keypresses. So it's like it is aware Unknown is kind-of-sort-of there, but isn't offering it as a choice; that the directional picker has gotten somehow broken - at the very least changed - and I don't understand the rationale of why. We do USE 'unknown' type designations for streets in situations like short to mid-term road construction, and to explicitly prevent routing on street types that otherwise allow it (like ramps) so...
bz2012 wrote:something strange is going on around there. To the south and east, I see the symptoms you are reporting. To the west, segments act normally.
I don't know how far the 'three directions only' region extends.
bz2012 wrote:I submitted a report to support along with a link to our conversation.
mssusa wrote:bz2012 wrote:I submitted a report to support along with a link to our conversation.
Had something like this for a while in the intl server in my last session (3 hours until a few minutes ago). No more unknown type available and the direction arrows in the drop down list were displayed as html escape codes for special characters.
The arrows are fixed now, but I haven't paid attention to the Unknown type.
Time to sleep
shirlig wrote:4) Cones and old ranks are now synced and displayed everywhere as follows:
old rank 0 = 1 cone
old rank1 = 2 cones (currently not in use)
old rank 2 = 3 cones
old rank 3 = 4 cones
old rank 4 = 5 cones
old rank 5 = 6 cones (currently not in use)
old rank 6 = STAFF
Users browsing this forum: ispyisail