Get a sneak peek at whats next for Permanent Hazards on our April 7th Office Hours!
The place to get information and ask questions about everything to do with properly and successfully editing the Waze Map.

Use this forum for all general editing questions, and the sub-forums for specific types of Waze Map Editor features.

Post Reply

Problem Editing turns on map edit

Post by forserioussounds
I added a road that was on a road that has one way traffic in each direction. I added Harry Van Arsdale Jr. Avenue, and did some editing on Jewel Avenue. But now I cannot make turns valid from the north exit ramp from the Van Wyke Expressway to be able to make legal left turns onto Jewel Avenue and to be able to go straight back onto the entrance ramp for the Van Wyke Expressway. Also the Jewel avenue road to the left should be able to go straight and to turn right onto the entrance ramp. Here is the map: https://www.waze.com/editor/?lon=-73.64 ... 1325361669
forserioussounds
Posts: 10
Been thanked: 1 time

POSTER_ID:12415696

1

Send a message

Post by AlanOfTheBerg
ForSeriousSounds wrote:I see that the some of the above url do not have a Segment attachement. When I highlight those roads, I do not get the display on the left of the screen to be able to edit those roads, it doesn't say anything about the roads I have highlighted. I think that might be a browser error.
Turn off the Landmarks layer and reload from permalink.
AlanOfTheBerg
EmeritusChamps
EmeritusChamps
Posts: 23627
Has thanked: 568 times
Been thanked: 3478 times
Send a message
Wiki Resources: Map Editing Manual | alanoftheberg@gmail.com
Oregon-based US Ex-Global Champ Editor | iPhone13Pro - VZ

Post by AlanOfTheBerg
ForSeriousSounds wrote:How do you make the editing screen bigger, or full screen? when I click on a problem, it takes up half of an already small editing screen.
Have you read the keyboard shortcuts in the manual? Link in my sig.
AlanOfTheBerg
EmeritusChamps
EmeritusChamps
Posts: 23627
Has thanked: 568 times
Been thanked: 3478 times
Send a message
Wiki Resources: Map Editing Manual | alanoftheberg@gmail.com
Oregon-based US Ex-Global Champ Editor | iPhone13Pro - VZ

Post by elness
Seems like your permalink is way off, and should be more like this:
https://www.waze.com/editor/?lon=-73.83 ... TTTTTTTTFT

In fact, if you could select the segment(s) you're talking about and post the resulting permalink for us, that would make it even clearer. Those streets, expressways, overpasses, and ramps look like a maze of twisty little passages, all alike... :D
elness
Posts: 24
Has thanked: 8 times
Send a message
Last edited by elness on Wed Dec 05, 2012 6:55 pm, edited 1 time in total.
elness
AM for Manteca/Lathrop, California
https://www.waze.com/wiki/images/5/5a/W ... M_only.png

Post by elness
If you could select the segment(s) you're talking about and post the resulting permalink for us, that would make it even clearer. Those streets, expressways, overpasses, and ramps look like a maze of twisty little passages, all alike... :D
elness
Posts: 24
Has thanked: 8 times
Send a message
elness
AM for Manteca/Lathrop, California
https://www.waze.com/wiki/images/5/5a/W ... M_only.png

Post by forserioussounds
Yes, you're right, I copied and pasted the url, not the permalink :oops:
forserioussounds
Posts: 10
Been thanked: 1 time
Send a message

Post by forserioussounds
I was able to add the turn allowances on this road: roadhttps://www.waze.com/editor/?lon=-73.83 ... s=69839292

I cannot view or edit any turns on this road: roadhttps://www.waze.com/editor/?lon=-73.83 ... TTTTTTTTFT you should be able to go straight and turn right onto the ramp

I cannot view or edit any turn on this road: roadhttps://www.waze.com/editor/?lon=-73.83 ... TTTTTTTTFT you should be able to go straight and turn right onto Jewel Avenue.

I cannot view or edit any turn on this road: roadhttps://www.waze.com/editor/?lon=-73.83 ... TTTTTTTTFT you should be able to go straight and turn left onto the unnamed road (the short one in the middle)

I see that the some of the above url do not have a Segment attachement. When I highlight those roads, I do not get the display on the left of the screen to be able to edit those roads, it doesn't say anything about the roads I have highlighted. I think that might be a browser error.
forserioussounds
Posts: 10
Been thanked: 1 time
Send a message

Post by forserioussounds
Turn off landmarks and reloading from permalink... thanks for the tip. Ok, seems like the unlock did it. I was able to edit the turns to allow them for this intersection and all looks good now. Thanks for all the help.
forserioussounds
Posts: 10
Been thanked: 1 time
Send a message

Post by forserioussounds
How do you make the editing screen bigger, or full screen? when I click on a problem, it takes up half of an already small editing screen.
forserioussounds
Posts: 10
Been thanked: 1 time
Send a message

Post by Gyr1949
elness wrote: Those streets, expressways, overpasses, and ramps look like a maze of twisty little passages, all alike... :D
Maybe you could leave various objects on the segments. ;)
Gyr1949
Posts: 42
Send a message