Read the forum posting instructions.

If your country has a dedicated forum for unlocks or update requests. See this thread for details first.

Post Reply
Forum rules
BEFORE YOU POST HERE

Read these rules:
1. Use this forum ONLY if your country does not have a Dedicated Forum for update requests.
2. Read the forum posting instructions.

Lvl 3 Unlock - Newark Delaware

Post by jjwproperties
Hello,
This road is currently closed for the next 2 months, but was locked after the end points were removed.

https://www.waze.com/editor/?lon=-75.75 ... s=68512025

Thanks,
Joe
jjwproperties
Posts: 13
Has thanked: 3 times
Been thanked: 1 time

POSTER_ID:7992285

1

Send a message

Post by doctorkb
So... If it is closed, it should be detached... Is it?

What are you proposing to do, exactly? Have you PM'd the AM that locked it?
doctorkb
Posts: 4385
Answers: 4
Has thanked: 433 times
Been thanked: 1464 times
Send a message

Post by doctorkb
Sure thing.

When does the construction end? I'll put that as an Alternate Street note...
doctorkb
Posts: 4385
Answers: 4
Has thanked: 433 times
Been thanked: 1464 times
Send a message

Post by doctorkb
According to this:
http://www.deldot.gov/public.ejs?comman ... ortDisplay

It's actually between Steel & Fraser... should the segment that's SW of the one you linked also be disconnected?
doctorkb
Posts: 4385
Answers: 4
Has thanked: 433 times
Been thanked: 1464 times
Send a message

Post by doctorkb
Documenting your UR before I close it:
Problem: Chesapeake City Road is closed between Pilot Drive and Frazier Road. I had updated this, and removed the connections, but then GIBrett reconnected, and then locked the segment. Please see statement here about the closure can be found here. I would appreciate if a L3 mapper could unlock and remove the connection points until June 1st (or later). http://www.deldot.gov/home/newsroom/rel ... ml?id=4675
Reported on: March 23
doctorkb
Posts: 4385
Answers: 4
Has thanked: 433 times
Been thanked: 1464 times
Send a message

Post by jjwproperties
I did just that (disconnected the end points) on March 13th. I PM'ed the AM twice over the past week with no response. I would just like to again disconnect the end points as I travel this road 8 to 10 times a day. Thank you for your help and assistance.
jjwproperties
Posts: 13
Has thanked: 3 times
Been thanked: 1 time
Send a message

Post by jjwproperties
Looks perfect. Thank you for your help!
jjwproperties
Posts: 13
Has thanked: 3 times
Been thanked: 1 time
Send a message