Arnoniem wrote:imran222120 wrote:arno use tampermonkey to host the script
I did, and I don't like it. And that's a work-around, not a solution.
Mike-1323 wrote:doomedtx wrote:I've been getting permission errors when using JNF in conjunction with other commands. I'm guessing it might be due to the WME update, and therefore JNF might need an update too. For example, an unlocked dead-end segment is marked unknown and in the wrong place. I move it to the correct alignment, then QW to make it two-way and allow all turns. At the end I get a "you do not have permissions to make this change" or something like that. I undo the JNF actions, save, then QW again, save, no problems.
Is anyone else experiencing this?
Yes, but I think that is a bug in the newest version of the editor, not JNF. Can you confirm that it never happens when JNF isn't running?
Mike-1323 wrote:I think that if it is a dead end road then JNF will set it as 2-way. If it is an unknown direction with both ends connected to other segments then JNF doesn't change the direction.
drive4fun2me wrote:I am running chrome and have crx version 0.0.7.7 but for some reason, I am unable to use it. I select a segment and press the "Q" on keyboard and nothing happens. Can someone please help.
AlanOfTheBerg wrote:JNF was specifically designed to NOT enable the u-turn at the dead-end junction due to the way Waze overuses them. When the routing engine is fixed to stop doing this, then I'd agree that JNF could change.
Users browsing this forum: No registered users