Problem selecting horizontal segments
Many times, I cannot select segments that are horizontal (east/west) or near horizontal (say, less than 20 degrees or so).
Refresh/save/zoom in or out/move the map around does not usually make a difference.
Turned off all extensions. Same.
This happens using both FireFox & Safari on Mac OS and has been happening for + 6 months so it's not just the latest editor. Does seem a bit more prevalent as of last month or so.
If I grab an intersection or end node, drag it up or down, then I can select the segment, make changes then move the intersection/end node back to where it was.
Any one seeing something similar opr know of a fix?
Refresh/save/zoom in or out/move the map around does not usually make a difference.
Turned off all extensions. Same.
This happens using both FireFox & Safari on Mac OS and has been happening for + 6 months so it's not just the latest editor. Does seem a bit more prevalent as of last month or so.
If I grab an intersection or end node, drag it up or down, then I can select the segment, make changes then move the intersection/end node back to where it was.
Any one seeing something similar opr know of a fix?
Re: Problem selecting horizontal segments