Level 3+
Primary I would like to remove the street names from the ramps highlighted. The UR was reported by me because when exiting the Monaro Highway Waze instructed me to “Exit TO Monaro Highway”. I also consider that the secondary ramps for each left turn are not required and should be removed, nodes and turning restrictions corrected.
Level 5+
If any happen across the thread, and while I have the permalink, I would like to change the street name for the highlighted section slightly to the north from “Monaro Highway” to “Monaro Hwy” to match the surrounding segments.
And you’re right, I missed the names of the off-ramps. I’ve fixed that. I was mainly fixing the angle of the off-ramp as they were not correct in that area.
@ps_au: I removed the street name from that segment because I believe it’s ambiguous – acknowledging that GMaps labels it as Newcastle St and Newcastle St is the more major of Newcastle St and Dairy Flat Rd. Effectively I considered it a larger version of, say, this intersection, where the centre segment is effectively the ‘middle’ of the intersection, an anonymous stretch of bitumen, and not part of either Cunningham Street, or Barrallier street.
I expect with the new naming the navigation directions from A to B per this route would be as follows:
Keep left: Exit to Newcastle St, Fyshwick
Keep right: to Dairy Flat Rd, Fyshwick
Turn right: to Newcastle St
If what I’ve interpreted from what I’ve read is correct, leaving that stretch blank will cause the last instruction to become “Turn right: to Dairy Flat Rd” and will not adversely affect navigation instructions for any other routes – i.e., the inverse scenario should still say “turn right to Newcastle St” and leaving Fyshwick via Newcastle St (as most of the traffic at this intersection would be doing) would still say, turn right to Monaro Hwy.
As for the rest of it, you’ve addressed the UR (ramp naming). Given you’ve been editing it, am I correct in assuming you’re happy with the rest of the setup? If so, then please lock it all back up.
